Windows 3.1 setup error6/16/2023 ![]() So it might be better trying with an older version of VMWare. Note that VMWare don't support Windows 3.x on Workstation 10 (last supported in version 9). If it still doesn't, check your CONFIG.SYS/AUTOEXEC.BAT for anything that's unnecessarily loaded (especially if it's graphics related) that may be causing problems. If this works, that should be enough to let you continue your upgrades. ![]() If it doesn't work after this, try using the "VGA (version 3.0)" driver, this is the aforementioned driver from Windows 3.0. Windows will ask you whether you want to use the already installed driver or not, say "no" and it'll prompt for the install disks and re-install the driver. If it does, go back into setup (either from Windows or DOS, since you now have working Windows) and choose VGA. EGA - VGA is back-compatibel to EGA) and see if that works. If the in place upgrade works then youre set. b) turn off wireless (hardware off if available) c) in the menu select to not install updates during the in place upgrade. During the in place upgrade repair: a) manually disconnect Ethernet. ini files, run SETUP.EXE (in the installed Windows directory, not the install disk) from the MS-DOS prompt, choose a different graphics driver (e.g. Repair Install Windows 10 with an In-place Upgrade. ![]() The Windows 3.0 driver should work in Windows 3.1 anyway (in fact, Windows 3.1 lets you choose the 3.0 driver as an option, because it was more compatible with certain VGA-compatible cards and a few applications looked "wrong" with the slightly-different palette used in 3.1).īefore messing with the.
0 Comments
Leave a Reply. |